Heading Accuracy: 0.5 degrees while moving.Position Accuracy: 2 m and better with multiple good satellite signals.One additional non-plated mounting/antenna cable hole, 4mm in diameter.Four plated mounting holes, 3mm in diameter.External EEPROM for configuration storage.UART: 9600 baud by default, but is configurable from 4800 to 115200 baud.On board LED will blink after module acquires a position fix and will continue blinking as long as the module has a fix.27 seconds to first fix (TTFF) for cold starts.WAAS (Wide Area Augmentation System) enabled GPS unit.Only recommended for baud rates of 9600 and less Two 1N4148 diodes in series between the TX pin on your 5V device and the RX pin on this GPS module (will drop voltage to ~3.6V) To use with a 5V logic device, such as an Arduino, we suggest level shifting the 5V TX signal using one of the following:.We have tested it with direct connection to the 5V serial pins on an Arduino and found it to work fine but extended periods of time may be different.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |